Search models, users, collections, and posts
ESP32 C3 Slim case snap fit
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
36
94
1
0
57
31
Released
Description
I made this tiny case because i needed the smallest footprint possible. I use these as car presence sensors in my vehicules. PLA works fine but PETG will be better if using inside a car.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)