K1 BACK FAN AIR DUCT
Copyright Claim
K1 BACK FAN AIR DUCT
Boost
15
20
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
15
20
4
2
56
2
Released
Description
Air pipe for the back fan of the K1.
It does not require any modification, it is stable and solid!
Simply disassemble the fan, insert the screws and screw back on.
You can change the direction of the fan when reassembling to have a second cooling fan for the models.
I inserted two rows with different tolerances for the screws, the offset can change depending on the material and the speed used.
If you need help send me a message.
Comment & Rating (4)
All
Boosted
Easy print (I printed in abs so it could stay in there when printing anything higher temp) printed without supports. Great job @1971.design.lab 👍🏻
1
Reply
thx for the model, was looking for this today to add more cooling frm left side ,without the need of buying the second right vent and modyfiing the printer.
1
Reply
Doesn't the air go out rather than in with the fan at the back?
0
Reply
he literally adresses this in the model info, just flip the fan and it will suck air from the outside, but that requires reading.
3
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld