270 Degree Door Hinge - Designed for 3D Printing
Copyright Claim
270 Degree Door Hinge - Designed for 3D Printing
Boost
39
77
7
Print Profile(2)
Strong, 1 set, 0.2mm layer, 6 walls, 25% infill
39 min
1 plate
One left side bolt head up and one right. 0.2mm layer, 5 walls, 15% infill
1.4 h
1 plate
Boost
39
77
7
0
105
204
Released
Description
I use this for my 3D printer enclosures - sometimes you want to open the door and get it out of the way.
The mounting holes are for “6 gauge” or 4mm countersunk screws, the pivot is M4x30 cap screw (if you get a longer one with an un-threaded shaft portion and cut it down, it's even better).
Designed for 3D printing, not mimicking a metal or injection moulded part. Print in the orientation it loads in, no supports, minor overhangs.
Comment & Rating (7)
All
Print Profile
Strong, 1 set, 0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
Strong, 1 set, 0.2mm layer, 6 walls, 25% infill
spot on can’t go wrong
0
Reply
Print Profile
Strong, 1 set, 0.2mm layer, 6 walls, 25% infill
Perfekt
0
Reply
Print Profile
Strong, 1 set, 0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
One left side bolt head up and one right. 0.2mm layer, 5 walls, 15% infill
0
Reply
Print Profile
Strong, 1 set, 0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
Strong, 1 set, 0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld