This is a clutch stop for a 2017 MK7 GTI. It makes it so the clutch pedal doesn't have to travel as far down. There is a lot of dead space for the clutch to move. Car still starts and shifts with no issues.

Installation is easy. Just remove the rubber grommet under clutch, place the grommet in the 3d printed clutch stop. Insert Christmas tree clip. Then push in the hole and your done. I put a little bit of light foam padding in so that it would fit up a little better.

The only thing you need to source for yourself is the push rivet. I just happen to have some samples lying around.