Just a simple little model I put together for an up coming project going through its “testing” phase, however I figured someone else may find use for it as well.
 

Simply houses 2 1x5 DuPont connectors to keep them aligned and sliding around. Just a simple solution for what I had lying about for testing another project. 

they are friction fit, however I recommend adding just a dab of glue to keep them secure.

Standard print settings literally nothing special. 

Included an “exposed” variant for those who may be attempting to use on a socket, if theres enough intrest in it I may go out of my way to make it parametric to support a variety of other sizes.

it is WAY taller than it “needs” to be, only to add strain relief for any wires coming out, but allows shrink tubing to be inserted with the connectors themselves

Instructions:

Print with desired settings (min 2walls recommended)

Push connectors TOGETHER through the chamfered bit 

push untill the connectors are flush with face. 

IF using the shorter variant, shove the connectors through untill the desired