A fairly simple dishwasher slider for indicating clean/dirty dishes.

This model was inspired from rcaslis's model on thingiverse. I didn't like the colored edges on the outside of the slider due to the layer change, so I made my own version that uses separately-printed letters that press-fit in place. This also means you don't need an AMS to print this model. I used black, white, and orange Bambu PLA Matte filaments for mine, but any PLA will work just fine.

Definitely use a glue stick for everything that isn't the letters, this thing really likes to warp off the build plate. The tolerances on this thing are also pretty gnarly, but prints and assembles fine on my A1. I'll make print profiles with greater tolerances if enough people request it.

Assembly:

1. Press-fit the letters into their corresponding slots on the slider and backplate.
   • You may want to use a rubber mallet to help with this if needed.
2. Place the slider into the backplate, then glue the top plate onto the backplate using superglue.
   • Make sure the top plate is aligned such that the chamfered top edges are face-up. If you're using the provided print profile, this is the side that was on the print bed.
   • Be careful not to glue the slider to the backplate or frontplate!
3. Mount to your dishwasher using 3M tape or command strips.