Porinto is a maze based game, where the objective is to steal the trophies of the oponent and collect them on your altar located on center of the maze. It can be played with 2 players, up to 4.

It can be folded so it's easier to carry, so it can be played anywhere you want.

• You'll need 4 3x2mm cylindrical magnets if you want the lid to magnetically close, but you can also use a rubber band.
• Magnets I used: https://amzn.eu/d/hPPtO3O

Printing settings:

• You can print it with any material you want, I recomend using PLA
• No supports needed, you will need to print the “Muro”, “Seto”, “Altar” and “Templo” pieces upside down.
• Brim or raft is recommended for the smaller pieces, but you can try printing them without it.

Yo need to print:

• x8 “Seto X3”
• x8 “Seto X2”
• x16 “Muro”
• x8 “Altar” ( 4 different colors, 1 color by pair)
• x1 “Templo”
• x1 “Jefe”
• x4 “Personaje” (1 color each)
• x1 “Salta Setos”
• x1 “Armadura”
• x1 “Mentalista”
• x1 “Velocidad”
• x1 “Dado”
• x12 “Trofeo” (4 groups of 3, 1 diferent color each group)
• x4 “Cuadrante”
• x1 “Tapa Superior”
• x1 “Tapa Inferior”