As the title says this is a remix of another post. In the original the connection between the hat and the heart was too thin so it would not print correctly. You could turn on print thin lines but then the connection would be very flimsy. I also made a change that will make the hearts in the hat print the same color as the heart the gnome is holding. I also found the original had the color transitions slightly off. Mine are shown in the included photo. The second number is the last layer that color will print at. They are:

• 0-3 white
• 3.2-6.6 red
• 6.8-7 gray
• 7.2-8 blue

This is meant to be sliced using .2mm layer height. Anything else and it may not slice correctly.