Printed in PETG. Print itself came out fine. Only knocked a star off because the orientation of the parts on the build plate visually creates a mixed surface when assembled. The front part was face up and looks worse than if the the top face was on the print bed.
Also required some glue to assemble as the press fit was very loose.
also works perfect as iPad drawing tablet/stand
changed infill and layer height to save time also changed support z distance I will upload a print profile...
only thing i didnt like was the connectors... they dont fit they are too loose
The strenght of fitting depend in the slicer settings. In 3d file the play between assembly parts is about 0.4mm that is not too big ore too small. In last case you can use some glue )). Thanks for feedback
good print legs are loose they come apart to easy supports stick to much to the print causing it to rip part's of both ends of the print, I still use it to good for stand on the go.