This is a bit of a remix of a remix. I made this thing: https://www.thingiverse.com/thing:4690307

Which is a mash up of these two things:
Apple Watch Dock - https://www.thingiverse.com/thing:814577
PG9201 thing - https://www.thingiverse.com/thing:4550426 I used just the "charging pad plain" file.

Pictured are the charges this was designed for.

I got a request for the design file as they wanted to alter it for a Galaxy Note 10+. I made this in Tinkercad so there is no design file to give. So I made this instead. It is sized for a Galaxy Note 10+ and should accommodate it with a case on.It has not been tested! I would suggest printing the test piece to make sure it will fit your phone with it's case before printing the entire thing.

This the second design for the Note 10+. This one works with the Newer Galaxy Watch 3 charger which is very similar to an Apple watch puck and much different from the Galaxy Watch. Yeah it's all confusing I know. I have not tested the size of the hole for the watch puck but did model it based on the dimensions I was given.

As with the other Note 10+ dock I used the PG9201 model listed above. The watch puck holder is mine. As always feedback welcomed and let me know if anything needs to be adjusted.