Clean Up and Sand:

• Once the squeezer is printed, remove any support structures or excess material.
• Use sandpaper to smooth out any rough edges or imperfections. Start with a coarse grit (around 80-120) and gradually move to finer grits (up to 400 or higher) for a polished finish.
• Clean the squeezer thoroughly to remove any dust or debris.

Prepare the Toothpaste Tube:

• Take your toothpaste tube (make sure it’s not a hard plastic one) and flatten the end slightly. You can do this by pressing it against a flat surface or using your fingers.
• Be gentle to avoid damaging the tube.

Insert the Tube into the Squeezer:

• Locate the narrow slot in the squeezer. It should be designed to accommodate the flattened end of the toothpaste tube.
• Wiggle the end of the tube through the slot until it fits snugly. Depending on the tube’s material, you might need to apply a little pressure or wiggle it back and forth.

Squeeze and Use:

• Pull the squeezer toward the full end of the tube as far as possible.
• As you use the toothpaste, continue to advance the squeezer over time. This ensures that you extract every last bit of toothpaste from the tube.
• By doing this, you’ll make the most of your toothpaste and avoid wasting any contents.