A1 Series Hotend Box
Copyright Claim
A1 Series Hotend Box
Boost
17
14
6
Print Profile(2)
Faster 0.28mm layer, 2 walls, 15% infill
Designer
2.2 h
2 plates
0.16mm layer, 2 walls, 15% infill
Designer
2.9 h
2 plates
Boost
17
14
6
6
28
28
Released
Description
I've created this hotend box because all the models I found were too complicated. It requires four 10 x 3 mm round magnets as shown in the last picture.
Bill of Materials
Bambu parts
Purchase from Bambu Store
Comment & Rating (6)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Just what I needed to house the A1 series hotends and socks. The slot for a spare print bed is great too. Thank you!
The designer has replied
1
Reply
thanks !
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
It's good but the space for the nozzles is a bit to tight. 1 mm more space on each side would make them easier to remove. I'm using it without magnets. I tried it with but then it's hard to remove them.
0
Reply
One of my first “big” print on my new A1mini. Works like a charm, everything fit just right for me..
The designer has replied
1
Reply
thanks for the comment
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld