BaByliss Big Hair Luxe & Hair Dryer Holder
Copyright Claim
BaByliss Big Hair Luxe & Hair Dryer Holder
Boost
14
15
3
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
13.4 h
1 plate
0.2mm layer, 3 walls, 25% infill - Whit Support
Designer
12.6 h
1 plate
Boost
14
15
3
0
23
11
Released
Description
BaByliss Big Hair Luxe & Universal Hair Dryer Holder is easily printable from Petg or ABS.
A like would make my day :)
Comment & Rating (3)
All
this is what it looks like because of jo supports and only because I was here and had a plastic spoon handy to help build the bridge otherwise I can't even imagine how saggy that top middle would be
The designer has replied
0
Reply
Hello Jacob, I'm sorry it didn't print well. I use ABS (original Bambu lab ABS) printing without support as you can see in the picture without any problems.
Actually, the pla you used could not solve the bridging. Each filament has a data sheet where its properties are written.
If you are not sure about your filament, use support.
0
Reply
your print profile provided needs supports. I had to hold a plastic in the end to bridge the hair dryer part and even them it is a disaster. too much filament went into getting this far to open in the studio and add supports. your profile shared should have included them.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld