Small Textured Vase

I have set the layer height to 0.08mm to reduce the seam line visibility, which should not be a problem with vase mode but for some reason it shows up, I believe it is a bug in Bambu Studio / Prusa Slicer / Orca Slicer. Although hard to see in the image below the seam is quite visible irl.

The vase is 99mm tall, it can be scaled up but will take a very long time to print at the current layer height, if you don't care about the seam line printing at 0.2mm layer height is much faster.

The vase has over 1 million triangles so may slow your slicer down a little.

This vase was not designed to hold liquid.

The original vase was made using Make My Vase from MakerWorld which I have modified by adding the texture.

Powered by Make My Vase from MakerWorld (https://makerworld.com/makerlab/makeMyVase)