This is a HDMI Protector that I created to replace the provided CP-2 cable protector that was provided with the OM1 camera. This one was built around the Twozoh right angle HDMI cable found on Amazon. It was also designed to utilize the screw from the CP-2 cable protector to secure it to the camera.

Please note that it is tight when put togeather, so make sure you have removed all support material from the inside cavity. You may need to scrape a little on the inside cavity to make it fit. This was done to make sure it was able to push it securely against the camera.

Recommend printing it solid with 100% infill, .20mm, and with supports.