Mosewald14 did a great fixing the original model and all I did was extend it to fit the XL size (140mm/5.5 inch ) paper towels from Costco

3 walls or better

Turn on and use variable layer height, if you don't want the huge layer stepping (print time increase)

15%+ infill

52g of PLA or better

Slice and Print

2 hours on a CR-10 SP for each piece ( 60mm/s outside and top walls/ 125mm/s for everything else)

1 hour 4m on a Bambu for each piece (STD mode)

4x screw (counter sunk) to fit your needs

Thanks Mosewald14 for fixing this and AL_3D creating this simple but effective kitchen piece!