Carpio 2.0 wrist rest by thatguywith3D

thatguywith3D

Household>Office

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.12mm layer, 2 walls, 15% infill

1.2 h

2 plates

4.7(15)

Boost

181

Released

Description

3d scanned and edited version of the deltahub carpio.

I highly recommend printing the pads with TPU, 0.12mm layer height for a smooth surface and 5-10% gyroid infill for squishiness.

Supports are recommended for the pads.

Base can be printed with PLA, 10% cubic infill for strength and 0.3mm layer height.

Enjoy!

Comment & Rating (17)

@mingoo

Print Profile

0.12mm layer, 2 walls, 15% infill

works well, don't know how are you supposed to keep the pad on the bottom, should I use super glue?

The designer has replied

@fesca01

Boosted

Thanks a lot for your reply. Yes I tried to keep by pressure but doesnt works well so i choose to fit by means of a superglue or similar (not hot glue)

(Edited)

@Cav9871

Print Profile

0.12mm layer, 2 walls, 15% infill

perfect

@mastema

Boosted

我二次创作加了网格结构，不如原模型来的软

@Orochi_Nik

Print Profile

0.12mm layer, 2 walls, 15% infill

comfortable

@ggaetoo

Print Profile

0.12mm layer, 2 walls, 15% infill

realy nice 3d model. it fit nice under the wrist and it work also on my glass pad.

@gooddogsbrent

Print Profile

0.12mm layer, 2 walls, 15% infill

Other Issues:the model is great and the original mostly good (though I'd recommend increasing supports and printing the wrist pads at an angle to reduce the rough textures of layer lines and provide a smoother finish on those gentle curves). the only problem was the included tpu profile. I got some serious overextension in the top surface leading to some very rough patches that would be uncomfortable to rest my wrist on.