Desk cable clip (remix) Remixed by VkvitV

Remixed by

VkvitV

Tools>Organizers

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.12mm layer, 3 walls, 15% infill

Designer

1.1 h

1 plate

4.9(8)

0.16mm layer, 2 walls, 30% infill

55 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

If you will print raw files, then import holder and clip as one model. I printed my sample with a layer thickness of 0.2 (it turned out not bad), but I think with 0.12 it will be much better.

If you have any suggestions for improvement, write in the comments.

Comment & Rating (13)

@narettmd

Print Profile

0.12mm layer, 3 walls, 15% infill

awesome

@iflush21

Print Profile

0.12mm layer, 3 walls, 15% infill

Works as intended but did snap a little while trying to close it for the first time.

The designer has replied

@VkvitV

I'm afraid that the reason is either the filament or the printer not being calibrated. Such moving parts will not tolerate average quality of either.

@iflush21

Replying to @VkvitV :

Yea I don't think that's the case considering my printer isn't "average" ... My filament stays at a great temperature in my AMS . and I have a fully calibrated P1P with no issues. It's the tolerance for the locking mechanism, it's very tight when trying to close .

@VkvitV

Replying to @iflush21 :

The fact is that if it were a tolerance problem, it would happen to everyone including me. When I can't get someone else's model to work and I see a lot of happy users, I think the problem is on my side. It's a shame you didn't get a good model, but it's not the model's fault.