Magnetic Poop Chute
Copyright Claim
Magnetic Poop Chute
Boost
9
9
8
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
9
9
8
1
65
60
Released
Description
This Poop Chute sits on the surface where your printer is and is held against the printer via 6 6x2mm magnets.This chute is not meant to hover above the floor/table/shelf of your printer, the magnets just ensure it doesn't fall over, or off if you don't have that much room behind the printer, and to keep it against the printer with anti-vibration feet.
Comment & Rating (8)
All
Nice print, Perfect for P1P. Thanks
1
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
it works nice and basic
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld