An adaptation of Matt3ry's Dragoon Storm for the Burst System.

To assemble it you will need:
-1x Spring (It pushes the Burst System's Lock

-2x Small nails with a round-head (For holding the driver together, like the picture)

- A Soft Filament for the rubber tip. (I used PLA FLEX to simulate the rubber tip)

You could also use super glue instead of the pair of nails, but It won't be strong enough for some matches. All you need to do is put all the driver's parts in place, heat the nail and push downwards. I also like to fuse together the gaps for extra resistance. Then, stick the soft tip with a bit of super glue.

I personally used PLA for this print, and it didn't break after many battles.