bubble wand
Copyright Claim
bubble wand
Boost
4
13
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, scaled 170%, PETG Translucent
50 min
1 plate
Open in Bambu Studio
Boost
4
13
5
0
15
7
Released
Description
A small bubble wand
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, scaled 170%, PETG Translucent
Not bad overall, but hard to dip into bubbles b/c the handle isn't angled. Recommend adjusting angle of handle. Photo shows the handle after my kiddo bent it to put into the bubble water.
The designer has replied
1
Reply
i aint designing it. i just added a profile. will look into this. hence I noticed the same. that the angle is a bit of an issue for small pots.
0
Reply
Love this!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, scaled 170%, PETG Translucent
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, scaled 170%, PETG Translucent
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld