Search models, users, collections, and posts
Wall Loop
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 10 walls, 0% infill
Designer
45 min
1 plate
Open in Bambu Studio
Boost
2
5
0
0
7
2
Released
Description
Made this remix off of this model. https://makerworld.com/en/models/794448-wall-mounted-loop-hook-hanger-for-leashes?from=search#profileId-733372
made it so I could zip tie a baby gate to my wall without the baby gate hard wear to keep my dog in a specific area of our living room after surgery. Just made the top half circle a lot thicker and printed it on its side so the layer lines would cause a week point connecting to the flat surface. Printed in generic white PLA with like 8 walls so its 100% infill without having to do infill.
Comment & Rating (0)