Flying Butterfly
Copyright Claim
Flying Butterfly
Boost
205
350
55
Print Profile(3)
PLA 0.16mm layer, 2 walls, 15% infill
12 min
1 plate
A1 Mini - Fast Print - 0.16mm layer, 2 walls, 15% infill
11 min
1 plate
0.16mm layer, 2 walls, 15% infill
12 min
1 plate
Open in Bambu Studio
Boost
205
350
55
1
849
505
Released
Description
Fun wind up butterfly that's easy to build. Use a 30mm rubber band and surprise your friends!
How to Build and Fly
1 - cut out a little washer, can use any smooth material (e.g pop can, smooth plastic)
2 - assemble in this order top wing → washer → body and put the hook through all of that
3 - use any sort of glue to attach hook to the top wing
4 - slightly bend wings in one direction, e.g both wings bent right
5 - wind up ~30 times and watch it fly
Comment & Rating (55)
All
Print Profile
PLA 0.16mm layer, 2 walls, 15% infill
(Edited)
The designer has replied
1
Reply
you can alwasy look at the comment section. also this has nothing to do with my settings as i am only making the gcode file not the actual model. thank you
0
Reply
Yes, the printing profile is absolutely perfect
0
Reply
still your rating has nothing to do with my profile...
0
Reply
翅膀角度调整下，就可以飞起来
You can fly by adjusting the angle of your wings
2
Reply
Print Profile
A1 Mini - Fast Print - 0.16mm layer, 2 walls, 15% infill
can't even be assembled
0
Reply
Print Profile
PLA 0.16mm layer, 2 walls, 15% infill
looks great, can’t wait to try them
0
Reply
Print Profile
PLA 0.16mm layer, 2 walls, 15% infill
0
Reply
Is there a certain way the wings need to be bent in order to fly correctly?
The designer has replied
0
Reply
No particular way, just as long it's all in one "motion." It looks like your rubber band might be a bit short
0
Reply
Print Profile
A1 Mini - Fast Print - 0.16mm layer, 2 walls, 15% infill
Good yard decoration printed in petg!
0
Reply
Print Profile
A1 Mini - Fast Print - 0.16mm layer, 2 walls, 15% infill
worked ok.
0
Reply
Print Profile
PLA 0.16mm layer, 2 walls, 15% infill
Very flimsy, but overall good for a little bit of fun for my kids. Doesn’t really need a shim, just need to be careful when gluing the hook. The hook was fiddly, but worked fine.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
thanks for sharing
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld