Search models, users, collections, and posts
Knife Holder Section
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
4.9 h
1 plate
Open in Bambu Studio
Boost
1
3
0
0
1
0
Released
Description
Content has been automatically translated.
I printed this knife holder: https://makerworld.com/en/models/2031451-chopstick-and-knife-holder#profileId-2190770
I recently bought a new kitchen knife and found it was 9.5cm wide, so the original knife holder could no longer be used. I redesigned the knife holder section myself. The knives are now placed diagonally, with the widest slot being 11cm wide. I then added 1cm to the original height of 6.5cm, increasing it to 7.5cm, so my new kitchen knife could fit.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)