These are printable patterns based on the pattern located at - http://eatpraycreate.com/2020/03/diy-face-mask-tutorial-and-pattern.html

These have been sized based on their recommendations so no additional scaling needed.

I have the print set to be only 1mm in height, but feel free to scale the Z-axis if you want it to be a bit more sturdy. We found 1mm is fine and works well.

I have a hole in the middle of each mask for pins to hold the fabric in place while using. I also have labeled the sizes for quick reference.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.32

Infill:

Notes:

I cranked up the layer height cause I wanted to pump this out fast. .32 was only 3 layers and took between 30-50 minutes each pattern and the 1mm height is fine.