Human Skull, Anatomically Correct

Remixed by
Copyright Claim

Human Skull, Anatomically Correct

Remixed by
Boost
477
1083
142

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.28mm layer, 2 walls, 5% infill
0.28mm layer, 2 walls, 5% infill
13.4 h
2 plates
4.7(79)

0.2mm layer, 2 walls, 15% infill -- printed in parts
0.2mm layer, 2 walls, 15% infill -- printed in parts
18.9 h
4 plates
5.0(17)

Open in Bambu Studio
Boost
477
1083
142
136
2.3 k
775
Released

Description

Anatomically Correct Skull Model.

Can be printed in one, two or three pieces.

Pieces require support as shown in photos.

Model is perfect for a display piece or even science project.

 

Happy printing!

Comment & Rating (142)

Please fill in your opinion
(0/5000)

Boosted
Excellent model, the skull was immediately used for a still life. Thanks
Show original
3
Reply
erm ackshully the anatomy of the mandible is quite in ackreate
2
Reply
You can get the lower half from the skull on printables that this is a remix of...
0
Reply
Print Profile
0.28mm layer, 2 walls, 5% infill
Top 👍🏼 only a support stuck to the plate, but that was my fault 😊😊✌🏼✌🏼
The designer has replied
Show original
0
Reply
Thanks for sharing!
0
Reply
Replying to @angel4964 :
no Problem 😊👍🏼
1
Reply
A nice skull but took ages to get the supports off,I did it in bone white then aged it
0
Reply
How did you age it ?
(Edited)
2
Reply
Replying to @user_820176864 :
He went back in time and buried it in what would today be his back garden. Then he came back to the present and dug it up. Easy!
2
Reply
Print Profile
0.28mm layer, 2 walls, 5% infill
really thick layers but over all amazing!
1
Reply
Print Profile
0.28mm layer, 2 walls, 5% infill
Very nice model. Thank you
The designer has replied
0
Reply
Thanks for sharing!
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill -- printed in parts
Nice I like it, it would be helpful it there's a way to assemble the parts without the need to glue them so whenever you need to detach them, to do so. for study and explanation purposes
1
Reply
Boosted
Print Profile
0.28mm layer, 2 walls, 5% infill
Looks great! Supports were a pain in the butt, which was fully expected. End result totally worth it, though I ended up using .08 layers with a gyroid infill, rather than .28 layers. Took a lot longer, but I think the extra detail is worth it.
The designer has replied
0
Reply
Thanks for sharing!
0
Reply
Print Profile
0.28mm layer, 2 walls, 5% infill
Not actually fully anatomically correct, but still a nice print!
The designer has replied
0
Reply
Thanks for sharing!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill -- printed in parts
Incredibly good! The segments are also chosen in perfect places
Show original
1
Reply