Small Nutcracker for Hazelnuts
Copyright Claim
Small Nutcracker for Hazelnuts
Boost
5
4
1
Print Profile(1)
1 set, 0.2mm layer, 2 walls, 15% infill
1.3 h
1 plate
Boost
5
4
1
0
14
19
Released
Description
Simple to print nutcracker for small nuts.
Works well with PLA. I use Numakers PLA+
Print as hot as possible with as little little cooling as possible for maximum strength.
Comment & Rating (1)
All
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
Printed quite well, was a little tough to get the threads going, but I usually expect that. Functionally it's not actually very great at cracking anything more than a peanut or pistachio shell.
0
Reply
No more
License
This work is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld