If you like my design please don't forget to give me a boost!
it is a piece adapted for an Anet A8, with the situation of the sensor in another different position, added a nut and with the pin turned, it is important to know that the optical sensor can not connect directly to the plate of the anet if not that it is necessary either to put marlin or to reverse the logic of the switch according to this: https://www.thingiverse.com/thing:2064022
Printer:
Anet A8
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25
Notes:
depending on your printer it may be necessary to establish a horizontal expansion of -0.25 so that the inner part slides without difficulty
Category: 3D Printer Parts