Search models, users, collections, and posts
Claw Keycap
IP Report
Print Profile(2)
ironing top, better surface, simplier support, 0.16mm layer
18 min
1 plate
0.2mm layer, 2 walls, 15% infill
26 min
1 plate
Open in Bambu Studio
Boost
454
1386
82
36
2 k
1.2 k
Released
Description
Content has been automatically translated.
A simple claw keycap with a decent size, tested and functional. It’s usually used to replace the escape key as a decoration. The bottom side of the keycap is not visible when used, so it’s recommended to have the design facing up and enable normal supports.
A simple paw keycap. The size is proper and has been installed on my keyboard. It is recommended to substitute the esc key. To print it, as the the downside is not visible when using a keycap, it is quite ok to turn on support.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (82)