After having seen and tested different models of poop buckets for my X1C, I have made my own version that corrects all the defects that I have found in the previous ones.
I have preferred to make a version with higher walls because the smaller ones cause poop expulsion failures or they come out of the bucket, so although they use less filament, they do not fulfill their function.
I also preferred to make it slightly wider to accommodate more poop in the bucket.
Another problem that I have encountered is that, due to the vibration of the machine, the traditional models did not stay in place, again due to this they were of no use. To solve this, six housings have been optionally designed to place small 5x3 mm magnets, the most common and economical, which will allow the part to be fixed to the machine.
I publish two models, one multicolor and one with a single color, the difference in printing time is significant.
If you need a poop bucket that performs its function without problems, this is the one you need.
It should work equally well for the Bambu P1P and P1S except for attaching with magnets, since both are made of plastic
Enjoy it!!