Modification to cut the controller power when the replica is in safe mode.

Reasons to consider this modification:
1. Easy access to the programming web interface - simply press the shooting trigger and switch from semi to single.
2. Reduce power consumption when your replica is in safe mode.
3. Allows you to create a shorter trigger pull.

How to:
1. Print the necessary parts.
2. Purchase microswitches or retrieve them from an older board (I used an identical switch to the one from auto mode).
3. Use the printed part with a hole to drill the selector plate.
4. Cut the ground wire and run it through the microswitch.
5. Insert the microswitch into the designated place.
6. Apply some hot glue, followed by super glue.
7. Adjust the hole in the selector plate if necessary.

Attention! I am not responsible for any permanent damage to your FCU. Please be very careful with the wires.

Microswitches: https://www.aliexpress.com/item/1005004069517525.html?spm=a2g0o.cart.0.0.5c3938dazvpENT&mp=1