Super Modell die Supports waren bei mir etwas schwerer zu entfernen aber ansonsten gut, für meinen Geschmack sitzt allerdings das Filament mit der Schachtel zu streng drin
Strength Issue:I really wanted to like this design but a full spool box on this one hinge really bends. Either PLA is not the answer to print this holder or it needs to have two hooks to really hold the box well without sagging.
it was bambu basic PLA. Maybe if I used a stronger type of infill it would hold better. There is a chance I could have edited it. Also, if you have only one, it is a bit wobbly considering there is only one point of contact to the board.