Designer Towel Holder / Hook by schiko

schiko

Household>Other House Models

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 100% infill

Designer

2.1 h

2 plates

4.6(27)

Open in Bambu Studio

Boost

162

209

Released

Description

Best printed upside down with 3 walls and 100% infill to get it very strong. PLA works fine.

No support needed.

Attach it to the wall with double-sided adhesive tape.

Update 2024-01-10: I added a version with closed sides.

I originally posted this model at Printables.

Comment & Rating (33)

@Cyrius_Simon

Print Profile

0.2mm layer, 3 walls, 100% infill

impression en 100%

@firefighterogre

Print Profile

0.2mm layer, 3 walls, 100% infill

printed perfectly wife was looking for a kitchen towel holder this morning and now she has one

@hologos

Print Profile

0.2mm layer, 3 walls, 100% infill

Printed fine, a little too big for my towel but it's my fault I didn't check the dimentions. ;)

@faluethi108

Print Profile

0.2mm layer, 3 walls, 100% infill

Failed literally every time (6 tries) at the same point on multiple different printplates (i even cleand them for a second try buth didn't help. Maybe it's because a collision of the nozzle with the print?

The designer has replied

@schiko

Did you try to print the version with the closed or open sides? The 'open version' has a modifier to slow down the print speed at the top.

@faluethi108

Replying to @schiko :

I printed the open one. I will test it with a brim, maybe it will work. Normally I don't have adhesion problems

@bbrunners

nah i have the same, it's a slicer issue or something. ANY model I put a modifier on, I get colisions... possibly due to overextrusions. Tried it just now with a simple cube and a modifier on a clean new profile... messes the thing up!