XL Easter Eggs
Print Profile(12)
Description
These Easter eggs are larger than normal. Actually, they are about the size on an emu egg! I would suggest that you choose 1-3 eggs and display them together. Adding extra eggs printed at varying scales can also look very nice. I have successfully tested them down to 25% scale with the exception of the Lattice Egg. The lattice is a retraction nightmare at smaller sizes. They should scale upwards without issue as well, but beware - they are pretty large already!
Check out my other holiday models here.
Print Settings
Because of the size, these eggs take a while to print. I found that I could speed up that process by limiting infill to critical areas only. Most of the examples above were printed at 0.2mm layer heights.
The following filaments were used in the pictures above:
- MatterHackers Quantum Blue Raspberry PLA
- MatterHackers Quantum Green Raspberry PLA
- MatterHackers Quantum Blue Yellow PLA
- MatterHackers Quantum Blue Green PLA
- MatterHackers Quantum Silver Gold PLA
- MatterHackers Quantum Pink Purple PLA
Membership
Are you looking for a Commercial License for all JamesThePrinter models?
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (869)