Remixed AT-AT Pot plant
Remixed by
Copyright Claim
Remixed AT-AT Pot plant
Remixed by
Boost
73
156
17
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.7 h
2 plates
Boost
73
156
17
1
165
137
Released
Description
A remix of Caleb Timoteo's excellent AT-AT pot plant. The main goal was to separate the parts so the base could be printed in white, with the AT-AT in grey.
I ended up making a hoth planet base plate, which is recessed for the AT-AT to fit neatly into.
I also moved the pot plant drain holes to the front of each 'pot’ to help them drain a bit easier. They drain through the baseplate.
Some other minor tweaks to the AT-AT to help make it print easier.
Hope you like it.
Comment & Rating (17)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Macht dich gut im Wohnzimmer, ich werde ihn jedoch nochmal vergrößern
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
👍 the bunny on the foot is a nice Easter egg
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Molto bello
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I used this profile on P1P with generic pla ana although I had to change filament near end as it ran out it printed really nicely with no problems
The designer has replied
1
Reply
great to hear, glad you liked it
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfekt, ich wollte das teil ohne boden haben!
(Edited)1
Reply
would love to sling you a few bucks for your work!!!
The designer has replied
0
Reply
Thanks for the kind gesture but please, I'm just glad you liked it. I only remixed it, P
please thank the original designer.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
this was smaller than my wife had been expecting
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld