Search models, users, collections, and posts
Glider
IP Report
Print Profile(1)
0.16mm layer, 2% infill, auto supports
Designer
3.4 h
2 plates
Open in Bambu Studio
Boost
19
48
4
0
38
16
Released
Description
This is a glider, it must print horizontal otherwise the wings will start to fray. The supports can be a pain to get off but a knife and patience makes it easier. Be careful with the horizontal stabilizer because it is very weak and easy to break. The bodys can be glued together with super glue, enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (4)