I designed these two little attachments for the Ikea Skadis because I wanted to keep my pen and my sharpie with the other tools, always at a good reach but without cluttering the workbench.

They are available in two diameters, 12mm and 17mm and they will suite pretty much any cylinder-shaped writing tool. 

The small diameter one will fit the Sharpie standing up but you don't want to keep the tip upward not to dry it too much. I suggest keeping them facing down as shown in the pictures.

The fitting on the Skadis is tight but they will fit I promise. I wanted it to be tight to avoid wobbling and to ensure stability when taking the sharpie and putting it away.

I printed both in yellow PETG but i assume PLA would work fine as well.

0.2 layer height with tree support enabled for the hooks.

Post a comment if you add these to your Skadis!