Portafilter Spill Guard for Breville Espresso Machine
Leanne3D
Shared by
Copyright Claim
Portafilter Spill Guard for Breville Espresso Machine
Leanne3D
Shared by
Boost
8
11
5
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
51 min
1 plate
Boost
8
11
5
0
21
25
Released
Description
Sliced with PLA as supports to make it print nicer. It only uses 1.26grams of PLA with minor changes as it's only the interfering layers that are PLA.
AMS Required.
Comment & Rating (5)
All
Took four tries to get a successful print. Print quality / finish was great at a 0.16mm layer height, but I struggled to separate the support without breaking the little pegs at the edges.
I tried printing with more infill, but what worked for me in the end was switching to minimal tree support.
Thanks
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
when removing the support, the 2 small side lips came off, so the different material layer didn't work for me.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Support Issue
Strength Issue:The layer with PLA interface material is very weak and broke immediately.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
No more
The user shared this model, but is not the original creator of it.
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld