Looking to spruce up your office? This two-in-one headphone and phone stand should do just that. Two different versions are available; with or without bubble patterning on the base.

Note that this is a very large print and may take upwards of 24hrs. Please also check that it meets the size requirements for your phone/headphones (phones smaller than 13x80mm should fit). Also note that some of the above pictures show an earlier version of the design with no phone holder.

Assembly

Once both TOP.stl and either one of the bases has been printed (print ONE of the two bases provided), simply remove the small amount of supports (if used) and glue the two components together using superglue or a similar adhesive.