As you can probably garner by the name, this is a very inspired MagSafe charging cube. But I'm cheap and wanted a bit of a reason to learn proper modeling techniques. 

It is split into 3 printed parts for both ease of replacing something as needed and for assembly. Use of 1 of these hinges and 4x total M4 screws to secure the top lid to the main body. The MagSafe puck and Watch charger puck are press fit into their housings. The Watch charger has ledges for it to easily slide on and flanges to prevent it from coming out too far.

There is a hole in the bottom of the back for the cables to route through. It has enough room for both a MagSafe's USB C cable and an older Watch USB A port to fit through. Combine with your favorite GaN charger (or two separate wall warts) and enjoy an adjustable charger perfect for the iPhone's Standby mode.

I've been using this at home and for travel for months now and it's been rock solid. Could use some artificial weight to help with accidental knocks. But it stands up very well.