Lightsaber Lamp Brick _Lego_ Star Wars by elikoll

elikoll

Hobby & DIY>Other Hobby & DIY

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 3 walls, 10% infill

Designer

22.7 h

5 plates

5.0(4)

0.2mm layer, 3 walls, 10% infill

15.4 h

5 plates

5.0(1)

Boost

241

355

325

Released

Description

Welcome to my wall mounted lightsaber lamp.

I wrapped 1m LED around the inside to have the best result.

Comment & Rating (11)

@outofbox11

Print Profile

0.2mm layer, 3 walls, 10% infill

all printed awesome.

@user_3821801093

which LEDs did you use to get that bright?

@outofbox11

Replying to @user_3821801093 :

I had some generic 24V laying around.

@user_1811156577

Very Cool Design. Removed the top section and added ventilation and a cap to the middle section of the outer tube. Also made couplings for the tubes. Made extra bracing for the inner tube. Needed to do modifications as the temperature inside the tube reached over 50 degrees with no ventilation and the 5050 LEDs I used which caused the central tube to soften and sag. I reprinted the central section with PETG and drilled holes to allow heat to pass thru from bottom to top. There is no warping now and temperatures are in check. The couplings are noticeable, glue would be a better if you have a steady hand.