Hello World!

I designed this Spool holder to be mounted under a desk of 2 cm thickness. It doesn't require drilling the wall and the weight is absorbed by the frontal hooks.

Each side of the holder is made up of 3 pieces:

• Bottom: is the larger piece that will hold the 2 wood cylinders of 25 cm
• Up-front: is screwed with the bottom and contains the hook
• Up-back: will be screwed with the bottom and contains two holes, to be screwed to the desk. This piece can be printed together with the Up-front.

The list of materials needed for this holder is reported below:

• 4x Threaded Heat set Inserts L: 3-8 mm M3
• 4x M3 screw L: 25mm (to connect the UP pieces with the Bottom)
• 2-4x wood screw M4 L: 20 mm, to connect the Up-back pieces with the desk (you can use just 1 screw on each side if the length of the staff is <= 70cm)
• 2x wooden dowel d: 25mm