Search models, users, collections, and posts
GolfStack Next Level Pieces
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
Open in Bambu Studio
Boost
0
2
0
0
2
2
Released
Description
Three variations on the basic rings:
Top and bottom angled the same direction
Top and bottom angled 180° opposite
Top and bottom angled 90° off
For these I printed in PLA with a honeycomb infill. The PLA is very slippery! Matte finish might take the challenge back down a notch ...
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)