Search models, users, collections, and posts
Card Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
2 plates
Open in Bambu Studio
Boost
4
31
0
0
7
4
Released
Description
This card holder allows people (i.e. children) to easily hold a whole hand of cards.
Print two of each part. Some supports may be necessary.
Two 12mm cap head M3 screws and a small extension spring are required for assembly. The screws serve as pins to retain the spring. The rest of the parts should snap together or be held together by spring tension. A bit of CA glue can be used to lock the covers in place if necessary.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)