Bike Watter Bottle Holder
Copyright Claim
Bike Watter Bottle Holder
Boost
16
34
8
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
2.4 h
1 plate
0.2mm layer, 3 walls, 15% infill
2.4 h
1 plate
Open in Bambu Studio
Boost
16
34
8
1
105
46
Released
Description
PETG recommended, since even the thick version when printed with PLA broke soon after testing it on my actual bike.
The diameter is 63 mm.
Comment & Rating (8)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
I printed the water Bottle Holder with normal PETG, so I improved the infill. But in generell very nice Print and until now it is doing a great job on my bike.
2
Reply
ciao, ma ci vogliono supporti?
The designer has replied
0
Reply
I’m not sure if you can get away without it. I used Prusa slicer’s tree supports and it worked great, though it did use a lot of plastic. Perhaps I’ll look into making the design more printable in the future
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Had to file the holes down as was too short to be able to put both screws in. Also a lot of mess from the supports. but I’ve managed to get it to fit and will see how it goes
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld