Easy Can Opener Extension - Assistive Device
Note: Compatible with Swing-A-Way can openers only

This Can Opener Extension is a snap-fit can opener extension aid for Swing-A-Way can openers. A 75mm extension arm paired with ergonomic knob options, connected by a single 60002RS sealed bearing, allow use of the opener with much less effort. The Can Opener Extension has a snap-fit mount, making it easy to attach and remove for cleaning and storage.

Hardware

1. M3x6 Socket Head Cap Screws QTY: 2
2. M3 Nut QTY: 2
3. 60002RS Sealed Bearings or Equivalent

Assembly Instructions

1. Installing Bearing

   • Press fit (#3) 60002RS bearing fully into knob
   • Press fit knob/bearing assembly onto spindle of Extension Arm.stl
     Note: Depending on your printers tolerance, you will need to add a non-expanding
     adhesive around spindle to secure the bearing. If you must use this take necessary
     precautions and DO NOT use until adhesives have fully set.

2. Attach Mount

   • Take Open Mount v2.stl and use one of the M3x6 screws to press/pull in both M3 nuts.
   • Place the pre-assembled Extension Arm.stl into position on Open Mount v2.stl, with the
     arrow facing towards the knob, and fasten down with the 2 M3x6 socket head cap
     screws.
3. Install Can Opener Extension
   • Snap in the Swing-A-Way knob into Open Mount v2.stl one side at a time starting with
     the side marked with the arrow.
   • While securely holding the arrow marked side of the mount, firmly press the extension
     knob until the assembly snaps into place.

Prusa

No

160