Sleeping Pikachu Keychain
Sleeping Pikachu Keychain
Boost
95
112
12
Print Profile(2)
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
Designer
6.9 h
1 plate
0.2mm nozzle, less filament changes, 0.1mm layer, 15% gyroid infill
1.8 h
1 plate
Boost
95
112
12
0
417
64
Released
Comment & Rating (12)
All
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
ok cool good job
(Edited)
0
Reply
Great model!
Just one issue I found (not sure how it's fixable) - there is a small part of the ears that is colored in yellow, while being completely invisible from the outside.
This causes a color swap on every single layer, instead of only the first 3 - which wastes time & material.
0
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
Very cute print. I printed it out to use as a present tag to give a hint to the contents of the present.
0
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
0
Reply
Excited to try this one!
1
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
really cute
0
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
Coloring was done too deep, a lot of filament swaps could have been avoided
0
Reply
Print Profile
0.2mm nozzle, less filament changes, 0.1mm layer, 15% gyroid infill
0
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld