Vibrating Sander

This sander is very simple and easy to use, greatly facilitating small craft projects or 3D prints made from both Resin and Filament. The cool part is that you can use a razor that you buy online.

The sandpaper holders are numbers 1 and 2, where 1 is for fine sandpaper and 2 is for coarse sandpaper.

RECOMMENDATIONS:

Print all parts with 100% infill and using strong filaments like ABS, PETG, or NYLON (do not use PLA).

Remove all supports and lightly sand all corners of the rails as shown in the GIFs above.

Lubricate well with white grease. I will leave the assembly link here for convenience.