Search models, users, collections, and posts
Tolerance Test (Long Version)
IP Report
Print Profile(2)
⭐ Optimized (Bal) - 0.2 layer - Standard Quality
Designer
58 min
1 plate
2 colors in one Print - 0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
Open in Bambu Studio
Boost
139
358
139
45
1.5 k
1 k
Released
Description
Tolerance Fitment Test - Long Version
0.05 to 0.40 mm tolerance test.
Try insert the round and square pegs into each hole and see how good your printer's tolerances are.
Note: Tolerances are for each mating surface. E.g. For 0.1mm, there is 0.1mm gap on all sides of the hole, and the holes are 10.2mm wide.
Note: The pegs are 10mm wide.
Short Version: https://makerworld.com/en/models/22224#profileId-20163
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (139)