Designed by me, turned into 3d using hueforge
printed in two parts on p1p in pla to make a larger print, but have also included the one print bed design (small)
there are no connectors, i just used velcro command strips on the back and lined it up on the wall
instructions below, you can sub for any black and white filament or use any colours you have on hand
happy printing
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA PolyTerra Charcoal Black Transmission Distance: 0.3
PLA PolyTerra Cotton White Transmission Distance: 2.5
PLA PolyTerra Cotton White Transmission Distance: 2.5
PLA PolyTerra Cotton White Transmission Distance: 2.5
Swap Instructions:
Start with Charcoal Black
At layer #7 (0.64mm) swap to Cotton White
At layer #12 (1.04mm) swap to Cotton White
At layer #18 (1.52mm) swap to Cotton White for the rest.